Unidata NEON Camera System (2502A)
The 2502A Neon Camera System is a Neon Camera Module
interfaced to a Neon Remote Module all housed within a rugged security camera
case, which can be mechanically adjusted to the required image view. The system
has lithium battery power for both the camera and the Neon Remote Module so it
can operate as a stand alone system without the need for external wiring or
Alternatively the 2502A Neon Camera Module can be supplied
as a stand alone component to be connected to an existing Neon remote Terminal
or Module. The Neon Remote Terminal or Module can be programmed to send a ?take
picture? command to the camera either routinely based on a fixed schedule or on
The camera electronics will take the picture and return the
image to the Neon Remote Terminal or Module which will then upload the image to
a Neon Server.
The view / focus / initial setup of the camera can be
performed on site using a laptop computer and companion camera software. This
process sets up the actual view needed on site.
Once these initial view parameters are set, the camera will
take a picture of the required view when requested to do so by the Neon Remote
Terminal or Module.
Typical set up
Daily picture taken and the image sent to Neon Server as a record of the site each day
On demand picture taken and image sent at any time when requested by the Neon Server if there is an unusual event or activity at the site
The Neon Server
Applications Software has the facility to view, store and recall images in a
similar way it does for logged data.